Sony Calculator VGC RBXX User Manual

VGC-RBxx Series Hard Disk Drive  
Replacement Instructions  
IMPORTANT!  
PLEASE READ BEFORE YOU START  
These easy instructions are intended to guide you through the replacement process.  
ü
ü
ü
To avoid electric shock please make sure product is turned off and disconnected from the power source.  
Remove jewelry before you begin work to avoid scratching the surface of your desktop computer.*  
Place your desktop computer on a clean, stable and covered surface to avoid damage to the computer's  
case.*  
Follow the ESD (Electrostatic Discharge) damage prevention instructions:  
o
Hold parts by the edges, away from exposed circuitry when possible.  
o
Do not walk around excessively as this promotes static build-up.  
ü
The appearance of the electronic components shown in the illustrations may be different from the  
components shipped. This slight difference does not affect the accuracy of these instructions.  
* Sony is not responsible for any loss of data associated with your computer or any damage caused by incorrect handling of the computer  
under these procedures. The terms of your Sony Limited Warranty continue to apply.  
2
Screws  
[1]  
[2]  
Step 2. Locate the power cable [1] and serial ATA cable [2]. Proceed  
and disconnect these cables from the hard drive. IMPORTANT! Some  
force may be required to initiate removal of the cables. Grasp the cable  
connectors where possible and take caution not to damage the cables.  
Pull with equal force on both sides of the cable connectors to remove  
them.  
Step 1. CAUTION!  
Disconnect the power cord. Failure to do  
so can result in damage to the unit or personal injury.  
Using the enclosed magnetic screwdriver, remove the two (2)  
indicated screws, loosening the chassis panel cover. Rotate the  
unit so the panel with the vents is facing you. Remove the panel  
and set it aside.  
Step 3. Using the enclosed magnetic  
Step 4. Pull the hard drive bracket  
enclosure from the unit in the direction of  
the arrow.  
Step 5. Using the enclosed magnetic screwdriver,  
remove the two (2) indicated screws and set  
aside.  
screwdriver, remove the two (2)  
indicated screws from the hard drive  
bracket.  
P/N 994630000  
Rev. E  
1/2  
 

Sherwood DVD Player SD 871 User Manual
Sony Ericsson Computer Drive MD300 User Manual
Sony Portable Speaker SRS PC71 User Manual
Sony Projector VPL CS2 User Manual
Sony VCR GV D300 User Manual
Stamina Products Elliptical Trainer 15 7250 User Manual
Sunfire Stereo Amplifier Symphonic Reference High Fidelity Control Center and Preamplifier User Manual
Sylvania Cassette Player SRCD822 User Manual
Symantec Patio Umbrella NIS2005 User Manual
TANDBERG Home Theater Screen TC30 User Manual